- Description
-
Details
Mikuni Power Jet Kit
Power Jet kits are used in 2-stroke engine applications to improve mid-range throttle response and add additional fuel to wide open throttle running conditions, especially with snowmobile clutches. Kit may be installed on most Mikuni TM and VM series motorcycle and snowmobile carburetors. This setup utilizes the Mikuni N102.221 series main jet for fuel metering.
Kit Contents:
- Power jet Holder and Nozzle
- Cap Screw
- Cap Screw O-Ring
- Nozzle O-Ring
- Screw and washer
- Screw 8-32 x 3/8
- Hose Nipple
- Fuel Hose
- Spring Clip
- Main Jets #80, #100, and #120
- Installation Instructions
Items needed to complete installation:
- Dill and drill bits 5/32" and #29
- Tap handle and 8-32 tap
- Hammer, and center punch
- Silicone Sealer
- Loctite or equivalent
- Mill, or hand file
Additional Information
Specification Details SKU MK-406 Brand Genuine Mikuni Country of Manufacture Japan Questions & Answers
-
Do you have a picture of the kit installed on a VM38? Where is the bottom fuel hole drilled ?
We don't have any photos, but if you do an internet search for "vm38 mikuni power jet" some low quality, vintage photos show the general idea. Unfortunately, I have not run across any that show the fuel feed. There are no provisions on the VM38 float bowl, so you will need to get somewhat creative for that carb.
Answer by: Niche Cycle (Admin) on Jun 22, 2015 10:12:00 AM
- Reviews
-
Write Your Own Review
- Fitment Information
-
- Product Question
- Shipping Estimation
-
You can use this section to calculate shipping costs on all available methods for the item on this page, or your entire shopping cart.
-
-
-
-
Yes No
-