- Description
-
Details
Fits VM30-VM36 round slide carburetors, TM32-TM38 non pumper flat slides and VM29 smoothbores. This is an o-ring style plug, not fiber washer.
- Approx. Thread OD: .620"
Additional Information
Specification Details SKU VM28/253 Material Aluminum Brand Genuine Mikuni Country of Manufacture Japan Questions & Answers
-
I need a float bowl drain plug for a VM32 carburetor. The surface looks flat as though it was made for a washer, not an O-ring.
The factory-supplied parts manual shows just one type of float bowl drain plug (VM34/42). This is brass and uses a flat washer (see links below):
http://www.nichecycle.com/ncs/mikuni/parts-by-category/float-bowls-plugs/vm34-42-plug-drain-by-mikuni.html
http://www.nichecycle.com/ncs/categories/carburetor/replacement-parts/4-053-holding-washer-by-mikuni.html
If your carb is an aftermarket VM32 (VM32-33 or VM32-193), you would replace the original float bowl plug with that part.
However,if your carb is an OEM carb, built for a specific motorcycle by Mikuni, it may not use the same parts as the aftermarket carbs.Answer by: rick c (Admin) on Dec 30, 2019 4:03:00 PM -
I have a 34mm Mikuni Carb on my four-wheeler. Will this plug fit my carburetor.
If the carburetor is OEM for your wheeler, this very likely WILL NOT fit. These are intended for use with Mikuni VM and TM series carbs. If you would like to, send us a photo of your carb so we can give you better information.
Answer by: Web Support (Admin) on Dec 27, 2018 1:24:00 PM
- Reviews
-
Write Your Own Review
- Fitment Information
-
- Product Question
- Shipping Estimation
-
You can use this section to calculate shipping costs on all available methods for the item on this page, or your entire shopping cart.
-
-
-
-
Yes No
-