Honda XR650R Mikuni TM40 Carburetor Conversion Kit with Remote Choke

Installation was relatively simple. Had to cut some eubber shims to slide inbetween the gas tank (stock tank) and backbone to keep tank from rubbing against pumper linkage. Running a full Big Gun exhaust, uncorked setup. Bottom end is much sharper, and throttle response is much quicker. Best part in my opinion is how much less flood prone this carb is on hot starts. Hot starts are no longer an exercise is endurance and profanity. That alone makes it a winner in my book, all other attributes just sweeten the deal

Plug and play, wish the fuel inlet was on right side but supplied fuel line works out.

Got it 2days ago, installed it with ease, off ridding the next day.

Simple job to fit, started first kick, adjust the idle and away we went

Replace the stock carb on my uncorked xr650r with the mikuni tm40. Easy install was jetted properly for my application. Only hung that would have been a little helpful is some basic instructions on fuel line placement and cable adjustment. Overall very happy with the mikuni, revs quicker and smoother than stock while delivering a noticeable power increase

Good stuff. Been fighting my stock carb for years. Who knew a 650r could run so good! All I did was drop the main 3 sizes to a 140 and turned in the fuel screw. Then used phone to shoot vid of squirt once mounted up. Set it to just miss the slide and stop at 3/4 throttle.
RUNS TERRIFIC! Thanks!!!! Only thing I would change is that fuel tubing LOL no biggie there.
I am at 4200feet. I may be a lil rich once it warms up more but major improvements and worth every penny if it holds up for many dirt miles!

The bike runs really well. Especially the bottom end improved a lot. The kit really is Bolt-on, and everything fits perfect. Together with a slip on pipe this is one of the best mods I have done to the bike.

I dont normally leave reviews, but my XR has never ran better.. has never started easier.. I am super stoked. Thank you.