Mikuni 24mm Yamaha TTR125 PreJetted Carburetor w/Silver Billet Cap

NEW CAP DESIGN!  This is the same pre-jetted carburetor that we have sold all over the world but now with a CNC machined cap.  We have designed this cap specifically for the TTR125.  Why?  Because this design will allow the use of the factory carb top seal, and cable retaining clip, keeping water and debris from entering the carburetor through the cable provision.

Pre-jettted carburetor for the Yamaha TTR125. Intended for stock, or mildly modified engines.  This will eliminate your remote choke.  The carburetor will need to be choked directly at the carb, or modified to accept the remote choke cable setup.  We have altered the carburetor cap to accept the factory throttle cable for quick and easy installation.  This carburetor directly replaces the factory unit, and hooks directly into the stock manifold and air filter boot.

The chart above shows the jetting specifications that we pre-install into the carb. 

• Genuine Mikuni Pre-Jetted carburetor
• Pre-Jetted for the TTR125 using genuine Mikuni jetting
• Includes tuning jets for future performance modifications.
• Modified carb top for stock throttle cable usage - Must use stock TTR125 carb top elbow

Note: If you are running a big bore kit with bolt-ons, see our 26mm pre-jetted TTR125 carb setup.  For later models with a push and a pull cable assembly, only the pull cable will be utilized.