Yamaha TTR125 VM24 Billet Cap

This is the same billet cap we use on our Mikuni VM24 and VM26 TTR125 carbs.  This replaces the original Mikuni cap, allowing proper use of the factory Yamaha throttle cable.  Typically when installing a Mikuni carburetor on a TTR125, the cap is simply drilled out to accept the cable end which often leads to a sloppy install, and unsatisfactory seal around the cable.  This cap allows use of the Yamaha retainer clip to keep the cable tightly secured into the cap, greatly reducing the possibilities of water, and dirt intrusion.

• For Mikuni VM24 and VM26 carbs
• Allows for use of the factory seal and securing clip
• Billet Aluminum
• Includes underside packing (cap seal)
• Designed and made in the USA

Note:  Cap sold exactly as shown.  For use with TTR125 models with a single throttle cable.  Does not fit the factory Yamaha carb, and may not fit non-genuine Mikuni versions.